Ryobi A18MS01 English Manual - Page 11
/2 X 9 In., Plywood, 3/4 In. Wood, Screws, Vertical, Strip, Front, Shelf Base - stand
View all Ryobi A18MS01 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 11 highlights
operation n Insert the 3/4 x 7-1/2 in. plywood strip horizontally between the 6 in. strips, making sure the long edge is flush with the base. n Pre-drill and countersink two holes; install screws. NOTE: The corners of the shelf can now be mitered, if desired, to remove sharp edges. n Place the 3-1/2 x 9 in. piece of plywood horizontally 1-3/4 in. above the vertical plywood strips. Make sure the left and right edges of the wood are flush with the sides of the base. n Pre-drill and countersink two holes in the center of wood as shown. Installing the workshelf: n Remove the 3-1/2 x 9 in. plywood and insert shelf between top and bottom rails of miter stand until edge of vertical 6" strips touch miter stand front rail. n Place the 3-1/2 x 9 in. plywood between the front and back rails of the miter stand. Re-align the pre-drilled holes in the top piece with the pre-drilled holes in the base of the shelf. n Install screws in pre-drilled holes to secure shelf. 3-1/2 x 9 in. plywood 1-3/4 in. WOOD SCREWS back rail front rail vertical strip shelf base Fig. 13 Fig. 14 11