Ryobi CSB124 Operation Manual - Page 14
Warning, Length Of Cut Scale, Optional Edge Guide Kit, Optional Dust Nozzle Kit
View all Ryobi CSB124 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 14 highlights
OPERATION WARNING: Always cut in a forward direction when pocket cutting. Cutting in the reverse direction could cause the saw to climb up on the workpiece and back toward you. Release the switch and allow the blade to come to a complete stop. Lift the saw from the workpiece. Clear corners out with a hand saw or sabre saw. LENGTH OF CUT SCALE See Figure 21, page 19. The saw is equipped with a length of cut scale on its base. It is parallel with the saw blade and can be used to measure the distance into the material the blade cuts. NOTE: Six inches is the maximum length of cut that you can measure. Also, it is accurate only when the depth of cut is set at full maximum depth. OPTIONAL EDGE GUIDE KIT See Figure 22, page 20. Use the optional edge guide kit, part no. 202218001 when making long or wide rip cuts with the saw. To assemble edge guide: Unplug the saw. Place edge guide through slots in base as shown. Adjust edge guide to the width needed. Tighten edge guide lock knob securely. To use edge guide: Secure the workpiece to prevent movement. Position the face of the edge guide firmly against the edge of workpiece. Guide the saw along the edge to achieve a straight rip cut. NOTE: The guiding edge of the workpiece must be straight for the cut to be straight. Use caution to prevent the blade from binding in the cut. OPTIONAL DUST NOZZLE KIT See Figure 23, page 20. You may purchase a dust nozzle kit, part no. 200673002, for use with the saw. The adaptor fits over the dust chute which is located on the upper blade guard. The nozzle attaches to the adaptor. NOTE: If you use the nozzle, you should always connect it to a standard vacuum hose. To attach dust nozzle: Unplug the saw. Lift lower blade guard. Orient adaptor to fit into the dust chute opening on upper blade guard. Secure adaptor with screw provided. Align hole in nozzle with raised lip on adaptor and snap into place when using a vacuum hose. 14 - English