Ryobi P742 User Manual - Page 5
Assembly, Operation - radio manual
View all Ryobi P742 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 5 highlights
ASSEMBLY WARNING: Do not use this product if it is not completely assembled or if any parts appear to be missing or damaged. Use of a product that is not properly and completely assembled or with damaged or missing parts could result in serious personal injury. WARNING: Do not attempt to modify this product or create accessories or attachments not recommended for use with this product. Any such alteration or modification is misuse and could result in a hazardous condition leading to possible serious personal injury. If any parts are damaged or missing, please call 1-800-525-2579 for assistance. OPERATION WARNING: Do not allow familiarity with this product to make you careless. Remember that a careless fraction of a second is sufficient to inflict serious injury. APPLICATIONS You may use this product for the following purposes: Listening to FM/AM radio, MP3 players, and other audio devices Charging USB capable devices Streaming audio from BLUETOOTH® enabled devices WARNING: Always remove the battery pack from the product when you are assembling parts, cleaning, or when not in use. Removing these energy sources will prevent accidental starting that could cause serious personal injury. WARNING: INSTALLING/REMOVING AAA BATTERIES See Figure 1, page 9. It is advisable to write down saved channels before replacing the AAA batteries. There is a 15-second time frame for replacing the AAA batteries. If the batteries are not replaced within 15 seconds, the radio will lose all settings previously stored in memory, and they will require reprogramming. The radio is not waterproof. Do not submerge in liquid. Failure to heed this warning could result in serious personal injury. Always use new alkaline batteries for replacement. WARNING: NOTICE: Danger of explosion if battery is incorrectly replaced. Replace only with the same or equivalent type. Always refer to the manual for any device recommended for use as an attachment or accessory. Proper use of any device, when attached to the radio, is the sole responsibility of the operator. Improper use may damage the device or the product. Remove the battery pack, if installed. Loosen the screw in the battery door. Remove door and set aside. Install two new AAA batteries according to polarity indicators inside the battery compartment. WARNING: This radio is capable of producing sound levels that can be dangerous to long-term hearing. Listening to music at high volume for any period of time can cause noiseinduced hearing loss. The higher the volume, the less time required before your hearing could be affected. NOTE: Do not mix old and new batteries. Do not mix alkaline, standard (carbon-zinc), or rechargeable (nickel- cadmium) batteries. Replace the battery door and tighten screw to secure. INSTALLING/REMOVING BATTERY PACK See Figure 2, page 9. To install battery pack: Place the battery pack in the radio, aligning the rib on the battery pack with the groove in the battery port. Make sure the latches on the battery pack snap into place and the battery pack is secured to the radio before beginning operation. 5 - English