Ryobi RY13010 Operator's Manual - Page 13

OPERATION using your left hand, pull the starter grip and rope until the engine runs.  Set the start lever back to the run position. NOTE: If the engine dies, set the start lever to the run position and pull the starter grip and rope until the engine starts.  Move to the rear of the machine and squeeze throttle lever to run. To start a warm engine:  Move the start lever to the START position and then immediately back to the RUN position. NOTE: This will set the carburetor to a fast idle setting for easier starting.  Pull the starter grip and rope until the engine starts. To stop the engine:  Place the on/stop switch in the OFF ( O ) position. cutting tips See Figure 13.  Keep a firm grip with both hands while in operation.  If grass becomes wrapped around the string head, STOP THE ENGINE, disconnect the spark plug wire, and remove the grass.  Use the tip of line to do the cutting; do not force string head into uncut grass.  Wire and picket fences cause extra line wear, even breakage. Stone and brick walls, curbs, and wood may wear line rapidly.  Avoid trees and shrubs. Tree bark, wood moldings, siding, and fence posts can easily be damaged by the line. TRANSPORTING THE UNIT  Turn on/stop switch OFF ( O ).  Make sure engine and exhaust are cool.  Keep unit level to prevent fuel spillage. 9 - English