Ryobi RY3716 Operation Manual - Page 15
Notice - chain brake
View all Ryobi RY3716 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 15 highlights
OPERATION To start a cold engine: n Set the on/stop switch to the RUN ( I ) position. n Make sure the chain brake is in the run position by pulling back on the lever/hand guard. n Fully press and release the primer bulb 10 times. n Pull choke knob all the way out to FULL CHOKE ( ) position. n Pull the starter grip and rope until the engine attempts to start, but no more than 5 times. n Push choke knob to HALF CHOKE ( ) posi- tion. n Pull starter grip and rope until engine runs. NOTE: Allow the saw to run in this position 15-30 seconds, depending upon the temperature. n Push the choke knob in to the RUN ( ) position. NOTICE: Failure to release partial throttle when chain brake lever is in the brake position will result in serious damage to the unit. Never squeeze and hold the throttle trigger while the chain brake is in the brake position. To start a warm engine: n Set the on/stop switch to the RUN ( I ) position. n Make sure the chain brake is in the run position by pulling back on the lever/hand guard. n Pull starter grip and rope until engine runs. 10X PRIMER BULB RUN HALF CHOKE FULL CHOKE FULL CHOKE POSITION Fig. 8 Fig. 9 Page 15 - English STARTER GRIP AND ROPE Fig. 10