Ryobi TS1342L English Manual - Page 30

MAINTENANCE Changing the Batteries See Figure 37.  Unplug the saw.  Remove the laser guide from the saw and lay it on a flat surface with the two screws facing upward.  Remove the screws and separate the laser guide cover from the laser guide support.  Remove the three button cell batteries using a non-con- ductive device such as a toothpick. Note: Replace the batteries with silver oxide batteries that have a rating of 1.5 volt and 180 mah (milliampere hour) minimum (Number 357 silver oxide only). When replacing the batteries, the laser guide should be thoroughly cleaned. Use a soft paintbrush or similar device, to remove all sawdust and debris. Do not attempt to activate the laser. The laser is activated by means of a centrifugal switch only while the saw motor is running and the laser guide is mounted on the saw.  After cleaning the laser guide and replacing the batteries, secure the laser guide cover to laser guide support using the two screws. For proper assembly, be sure to align the key on the laser guide cover with the key slot in the laser guide support. Tighten screws securely. Note: Aperture in laser guide cover must be aligned with aperture in laser guide support. WARNING: Use of controls or adjustments or performance of procedures other than those specified herein may result in hazardous radiation exposure. LASER GUIDE COVER LASER GUIDE SUPPORT SCREWS a BATTERIES Aperture Fig. 37 30