Ryobi YN250FSD Operation Manual - Page 11
Warning, Preparing The Tool For Use, No-mar Nosepiece, Adjusting The Exhaust
View all Ryobi YN250FSD manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 11 highlights
OPERATION WARNING: Always wear eye protection. Eye protection does not fit all operators in the same way. Make sure the eye protection chosen has side shields or provides protection from flying debris both from the front and sides. PREPARING the tool for use See Figure 2. Under normal use conditions, the tool should be lubricated before connecting the tool to an air supply. Add air tool oil into the air fitting on the tool once daily with minimal use, or twice a day with heavy use. Only a few drops of oil at a time is necessary. Too much oil will only collect inside the tool and will be noticeable in the exhaust cycle. Before connecting the tool, check the air compressor gauge to be sure it is functioning within the proper range of 70-120 psi. no-MAR NOSEPIECE See Figure 3. The no-mar nosepiece attached to the workpiece contact of the tool helps prevent marring and denting when working with softer woods. WARNING: Disconnect the tool from the air supply before removing or replacing the no-mar nosepiece. Failure to do so could result in serious personal injury. The no-mar nosepiece can be removed by pulling it down and away from the nose. To replace the no-mar nosepiece fit it into place over the workpiece contact and push up at the back to reseat. ADJUSTing the EXHAUST See Figure 4. The adjustable exhaust on the end cap of the tool allows the operator to direct the exhaust according to operator preference. To adjust, turn the exhaust cap until the exhaust blows in the desired direction. NO-MAR nosepiece QUICK-CONNECT air fitting Fig. 2 workpiece contact Fig. 3 ADJUSTABLE EXHAUST Fig. 4 11