Ryobi YN250FSD Operation Manual - Page 13
Loading The Tool With Nails, Warning
View all Ryobi YN250FSD manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 13 highlights
OPERATION loading the tool with NAILS See Figures 6 - 7. Connect the tool to the air supply. WARNING: The tool's driving mechanism may cycle when the tool is first connected to the air supply. Always connect the tool to the air supply before loading nails to prevent injury from unintended cycling. Always make sure the tool's magazine is empty at the beginning of each work session, before connecting to an air supply. WARNING: Keep the tool pointed away from yourself and others when loading nails. Failure to do so could result in possible serious personal injury. WARNING: Use only the nails recommended for use with this tool. The use of any other nails can result in tool malfunction, leading to serious injuries. WARNING: Never load nails with the workpiece contact or trigger activated. Doing so could result in possible serious personal injury Slide the pusher all the way to the rear of the magazine until it locks into place. With the nose of the tool pointed away from you, feed a strip of nails into the magazine. Be sure the nails are pointed downward as shown. Depress the pusher release located on the top of the magazine to allow the pusher to move the nails up to the driving mechanism. The pusher will stop when it rests against the end of the nail strip. . PUSHER NAILS PUSHER RELEASE PUSHER Fig. 6 PUSHER RELEASE Fig. 7 13