Samsung C34F791WQN User Manual - Page 36
PC/AV Mode, DisplayPort Ver., HDMI Mode, Source Detection, Key Repeat Time
View all Samsung C34F791WQN manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 36 highlights
PC/AV Mode Set PC/AV Mode to AV. The picture size will be enlarged. This option is useful when you view a movie. •• Set to PC when connected to a PC. •• Set to AV when connected to an AV device. ――This feature is only available on the widescreen models that include 16:9, 16:10 and 21:9. ――If the monitor is in HDMI 1, HDMI 2 or DisplayPort mode and the screen says Check Signal Cable or power saving mode activates, press the JOG button to display the function-button screen and then select the icon. You can select PC or AV. DisplayPort Ver. Select your Displayport. Displayport 1.1 supports High Bit Rate 1, while 1.2 supports High Bit Rate 2. ――Incorrect settings may cause the screen to go blank. If this occurs, check the device specifications. ――If the monitor is in HDMI 1, HDMI 2 or DisplayPort mode and the screen says Check Signal Cable or power saving mode activates, press the JOG button to display the function-button screen and then select the icon. You can select 1.1 or 1.2. HDMI Mode Select the HDMI mode to use. ――The supportable device and resolution may differ depending on its version. ――When the version is changed, the screen may blink or the setup window in your PC may be changed. ――When the setting is not appropriate, a blank screen may appear. In this case, check the specifications of the device. •• 1.4: HDMI 1.4 input is supported. The product supports the vertical frequency up to 50 Hz in the maximum resolution (3440 x 1440). •• 2.0: HDMI 2.0 input is supported. The product supports the vertical frequency up to 100 Hz in the maximum resolution (3440 x 1440). For use of HDMI 2.0, you must use the graphic card and the standard cable that support HDMI 2.0. Source Detection Select either Auto or Manual as the method to recognize input signal. ――Not available when PIP/PBP Mode is set to On. Key Repeat Time Acceleration, 1 sec, or 2 sec can be selected. If No Repeat is selected, a command responds only once when a button is pressed. 36