Samsung CLX-6220 User Guide - Page 26
Getting started, Setting up the hardware, Printing a demo Supplied software
View all Samsung CLX-6220 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 26 highlights
getting started 1. This chapter gives you step-by-step instructions for setting up the USB connected machine and software. This chapter includes: • Setting up the hardware • Printing a demo page • Supplied software • System requirements • Installing USB connected machine's driver • Sharing your machine locally Setting up the hardware This section shows the steps to set up the hardware, as is explained in the Quick Install Guide. Make sure you read the Quick Install Guide first and follow the steps below: 1. Select a stable location. Select a level, stable place with adequate space for air circulation. Allow extra space to open covers and trays. The area should be well ventilated and away from direct sunlight or sources of heat, cold, and humidity. Do not set the machine close to the edge of your desk or table. 2. Unpack the machine and check all the enclosed items. 3. Remove all the tapes. 4. Install the toner cartridges. 5. Load paper (See "Loading paper in the tray" on page 3). 6. Make sure that all cables are connected to the machine. 7. Turn the machine on. This equipment will be inoperable when mains power fails. Printing a demo page Print a demo page to make sure that the machine is operating correctly. To print a demo page: In ready mode, press and hold the OK for about 3 seconds, then release. Supplied software After you have set up your machine and connected it to your computer, you must install the printer software. If you are a Windows or Macintosh OS, install the software from the supplied CD and if you are a Linux OS user or UNIX OS user, download the software from the Samsung website (www.samsung.com/printer) and install. Machine software are occasionally updated due to release of new operating system and etc. If needed, download the latest version from the Samsung website. (www.samsung.com/printer) Printing is suitable for altitudes under 1,000 m (3,281 ft). Refer to the altitude setting to optimize your printing (See "Altitude adjustment" on page 1). Place the machine on a flat, stable surface so that there is no incline greater than 2 cm (0.79 inch). Otherwise, printing quality may be affected. Getting started_ 1