Samsung CXE1931 Owner Instructions - Page 11
Connecting VHF and UHF Antennas, to the TV/VCR
View all Samsung CXE1931 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 11 highlights
Chapter two INSTALLATION In this chapter, you will learn to connect your TV/VCR. Choose which of the following situations applies to your system, and follow the step-by-step instructions to set up your new TV/VCR. Connecting VHF and UHF Antennas to the TV/VCR If you do not have cable TV, you will connect the TV/VCR to one or more antennas. Before connecting, however, you must determine what type of lead your antenna has (The "lead" is the end of the antenna cable ). If your lead looks like this, you have a 300-ohm flat twin lead. (This is the type of lead on the rod antenna included with the unit ). If your lead looks like this. you have a 75-ohm round lead. (This is the type of lead on a coaxial cable ). Antennas with 300-ohm Flat Twin Leads The rod antenna included with your TV/VCR (except models CXD2512, CXD2514) uses 300-ohm twin flat leads. If you are using a different antenna (like a roof antenna) that also has 300-ohm twin flat leads, follow the directions below, but skip the first step 1 If you want to use the included rod antenna, push the stem of the antenna into the antenna mount at the top of the back panel. 2 Place the wires from the antenna under the screws on the 300-75 ohm adaptor (included). Use a screwdriver to tighten the screws. 3 Plug the adaptor into the terminal on the bottom of the back panel. continued... 2 . 1 C H A P T E R T W O: IN S T A L L A T I O N