Samsung DV520AEP User Manual (user Manual) (ver.1.0) (English) - Page 17
Connecting The Inlet Hose, Method1
UPC - 036725569874
View all Samsung DV520AEP manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 17 highlights
01 installing your dryer Connecting the inlet hose Method1 The dryer must be connected to the cold water faucet using the new inlet hoses. Do not use old hoses. 1. If space permits, attach the brass female end of the "Y" connector to the cold water faucet. 2. Turn the cold water faucet off. Y-Connector 3. Attach the straight end of long hose to "Y' connector. 4. Using pliers, tighten the coupling with an additional two- thirds turn. Do not overtighten, as it may damage the coupling. Duct Ehuast 5. Attach angled end of long hoses to fill the valve at the bottom of the dryer's rear frame. Screw on coupling by hand until it is seated on fill valve connector. 6. Using pliers, tighten the coupling with an additional twothirds turn. Duct Ehuast Frame (back) Do not overtighten, as it may damage the coupling. 7. Check that the water faucets are on. 8. Check for leaks around "Y" connector, faucets and hoses. Water Hose Method2 The dryer must be connected to the cold water faucet using the new inlet hoses. Do not use old hoses. 1. If "Y" connector cannot be attached directly to the cold water faucet, the short hose must be used. 2. Turn the cold water faucet off. 3. Attach short inlet hose to cold water faucet. Screw on coupling by hand until it is seated on the faucet. Short hose (Inlet to cold water) "Y' connector 4. Using pliers, tighten the coupling with an additional two- thirds turn. Do not overtighten, as it may damage the coupling. Long hose 5. Attach 'Y" connector to brass male end of small hose. Screw on coupling by hand until it is seated on connector. 6. Using pliers, tighten the coupling with an additional twothirds turn. Do not overtighten, as it may damage the coupling. Duct Ehuast Frame (back) 7. Attach angled end of long hoses to the fill valve at the bottom of the dryer rear frame. Screw on coupling by hand until it is seated on fill valve connector. 8. Using pliers, tighten the coupling with an additional twothirds turn. Water Hose Do not overtighten, as it may damage the coupling. 9. Check that the water faucets are on. 10. Check for leaks around "Y" connector, faucets and hoses. installing your dryer _17 DV520AE-02836B_EN.indd 17 2010-06-03 �� 5:38:26