Samsung DV52J8700EW/A2 User Manual - Page 20
Step 3
View all Samsung DV52J8700EW/A2 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 20 highlights
Installation Installation STEP 3 Connect the electrical wiring First, read through the "Electrical requirements" section, and follow these steps. 3-wire system 1. Loosen or remove the center terminal C block. A 2. Connect the neutral wire (white or center wire) of the power cable to the center, silver-colored terminal screw of the terminal block. Tighten the screws. B 3. Connect the other wires to outer D terminal block screws. Tighten the screws. E 4. Tighten the strain relief screws. 5. Insert the terminal block cover into the rear panel of the dryer. Then, secure the cover with a hold-down screw. CAUTION A. External ground connector B. Neutral grounding wire (white) C. Center silver-colored terminal block screw D. Neutral wire (white or center wire) E. ¾" (1.9 cm) UL-listed strain relief • To convert from the 4-wire system to 3-wire system, connect the ground strap to the terminal block support to ground the dryer frame to the neutral conductor. • Ring-type terminals are recommended. If using strap terminals, make sure they are tightened. 20 English %7+4@&/64JOEE