Samsung FTQ353IWUX User Manual (ENGLISH) - Page 51
POSSIBLE CAUSE, difficult to slide. - troubleshooting
UPC - 036725538481
View all Samsung FTQ353IWUX manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 51 highlights
06 TROUBLESHOOTING PROBLEM POSSIBLE CAUSE SOLUTION Oven not clean after The oven controls were not set a self-cleaning cycle correctly. The oven was heavily soiled. • See the section on self-cleaning on page 38. • Wipe up heavy spillovers before starting the self-cleaning cycle. Heavily soiled ovens may need to self-clean again or for a longer period of time. Steam from the vent When using the convection feature, it is normal to see steam coming out of the oven vent. As the number of racks or amount of food being cooked increases, the amount of visible steam will increase. • This is normal. Burning or oily odor This is normal in a new oven and emitting from the will disappear in time. vent • To speed the process, set a self-cleaning cycle for a minimum of 3 hours. • See the section on self-cleaning on page 38. Strong odor Fan noise Oven racks are difficult to slide. An odor from the insulation around • This is temporary. the inside of the oven is normal for the first few times the oven is used. A convection fan may automatically • This is normal. turn on and off. The shiny, silver-colored racks were cleaned in a self-cleaning cycle. • Apply a small amount of vegetable oil to a paper towel and wipe the edges of the oven racks with the paper towel. Display goes blank. A fuse in your home may be blown • Replace the fuse or reset the circuit or the circuit breaker tripped. breaker. Display flashes. There was a power failure. • Reset the clock. Drawer does not slide smoothly or drags. The drawer is out of alignment. The drawer is over-loaded or the load is unbalanced. • Fully extend the drawer and push it all the way in. See the page 46. • Reduce weight. Redistribute drawer contents. Warming drawer will A fuse in your home may be blown • Replace the fuse or reset the circuit not work. or the circuit breaker tripped. breaker. The controls are not set correctly. • See the chapter on using the warming drawer on page 16. Excessive There is liquid present in the condensation in the drawer. drawer Uncovered foods. • Remove the liquid. • Cover food with a lid or aluminum foil. The temperature is set too high. • Adjust the temperature to a lower setting. Food dries out in Moisture is escaping. the warming drawer. The drawer is not fully closed. • Cover food with a lid or aluminum foil. • Push the drawer in until the latch engages. Troubleshooting _51