Samsung HT-AS600 Quick Guide (easy Manual) (ver.1.0) (English) - Page 24
Before Calling for Service, Symptom, Check, Remedy
View all Samsung HT-AS600 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 24 highlights
Before Calling for Service Symptom Can't turn it on. It does not work when the button is pressed. Sound is not produced. Check • Isthepowercodepluggedintotheoutlet? Remedy • Connect the power plug to the outlet. • Is there static electricity in the air? • Are the speaker and external component connected properly? • Does the Mute function work? • Is the volume set to minimum? • Is the speaker setup selected to NONE? • Disconnect the power plug and connect it again. • Properly connect it. • Press Mute button to cancel the function. • Adjust the volume. • Refer to pages 19~20 to select LARGE, SMALL or YES. Picture does not appear when the function is selected. Remote controller does not work. The sound from each device is changed during stereo playback. • Isn't the external component connected properly? • Are the batteries exhausted? • Is the distance between remote control and main unit proper? • Is the left/right speaker or left/right input/output code connected properly? • Properly connect it. • Replace with new batteries. • Operate at close distance. • Check the left/right channel and properly connect it. Can't receive broadcasting. • Is AM or FM antenna connected properly? • Properly connect the antenna. • If the input strength of antenna connector is weak, install the FM antenna in a place with good reception. There is no sound from surround speaker. • Is the surround speaker connected properly? • Is S.SPK (Surround) set to NONE in Speaker Setup? • Is Surround Mode selected to Stereo? • Refer to pages 11~12 to connect it properly. • Refer to pages 19~20 to select LARGE or SMALL. • Refer to pages 20~36 to select other Surround Mode. There is no sound from center speaker • Is the center speaker connected properly? • Is C.SPK (Center) selected to NONE in Speaker Setup? • Is the Surround Mode selected to Stereo? • Refer to pages 11~12 to connect it properly. • Refer to pages 19~20 to select LARGE or SMALL. • Refer to pages 20~36 to select other Surround Modes. 45 Symptom Check Remedy Can't select Dolby Pro Logic • Is the input signal selected properly? ll Mode. There is no sound when playing DTS encoded DVD and CD. • Is analog input selected? • Select 2 channel Dolby Digital, PCM, and Analog input signal. • Check whether digital external component is properly connected and refer to page 18 to select the digital input. Product Protection Function Heat Protection • Protection function works if the main unit is overheated or power transformer is overheated. appears in the display when the " " function works. - If speaker terminal is shorted - If speaker cord is shorted If there is no problem when you turn it on again after turning it off, PROTECTION mark will disappear on the display and the unit will work properly. • If PROTECTION appears on the display, check whether speaker terminal is shorted and then turn on the device. 46 MISCELLANENOUS