Samsung HW-MS6500 User Manual - Page 32

Center Line, Wall Mount Guide, Holder-Screw, Bracket-Wall Mounts, Screws, Align the Paper Template's

Page 32 highlights

2. Align the Paper Template's Center Line with the center of your TV (if you are mounting the Soundbar below your TV), and then fix the Wall Mount Guide to the wall using tape. •• If you are not mounting below a TV, place the Center Line in the center of the installation area. 5. Push a screw (not supplied) through each Holder-Screw, and then screw each screw firmly into a support screw hole. 450mm Center Line 3. Use a sharp object, such as a pen or pencil, to mark the holes' positions, and then remove the Wall mount Guide. 450mm 6. Install the 2 Bracket-Wall Mounts in the correct orientation on the bottom of the Soundbar, using 2 Screws. CENTER LINE 4. Using an appropriately sized drill bit, drill a hole in the wall at each marking. •• If the markings do not correspond to the positions of studs, make sure you insert appropriate anchors or mollies into the holes before you insert the support screws. If you use anchors or mollies, make sure the holes you drill are large enough for the anchors or mollies you use. •• When assembling, make sure the hanger part of the Bracket-Wall Mounts are located behind the rear of the Soundbar. Rear of Soundbar Right end of Soundbar ENG - 26

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40

ENG - 26
2.
Align the Paper Template’s
Center Line
with
the center of your TV (if you are mounting
the Soundbar below your TV), and then fix
the
Wall Mount Guide
to the wall using tape.
If you are not mounting below a TV, place
the
Center Line
in the center of the
installation area.
Center Line
450mm
3.
Use a sharp object, such as a pen or pencil, to
mark the holes’ positions, and then remove
the
Wall mount Guide
.
450mm
4.
Using an appropriately sized drill bit, drill a
hole in the wall at each marking.
If the markings do not correspond to the
positions of studs, make sure you insert
appropriate anchors or mollies into the
holes before you insert the support
screws. If you use anchors or mollies,
make sure the holes you drill are large
enough for the anchors or mollies you
use.
5.
Push a screw (not supplied) through each
Holder-Screw
, and then screw each screw
firmly into a support screw hole.
6.
Install the 2
Bracket-Wall Mounts
in the
correct orientation on the bottom of the
Soundbar, using 2
Screws
.
When assembling, make sure the hanger
part of the
Bracket-Wall Mounts
are
located behind the rear of the Soundbar.
Rear of Soundbar
Right end of Soundbar