Samsung MU-PA1T0B/AM User Manual - Page 6
System Requirements
View all Samsung MU-PA1T0B/AM manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 6 highlights
System Requirements 1. USB 3.1 Gen 2 (10 Gbps) or USB 3.1 Gen 1 (5 Gbps) Interface Support USB (Universal Serial Bus) is a serial input/output interface standard for connecting various devices. T5's data transfer speed is optimal with USB 3 (USB 3.1 Gen 2 and USB 3.1 Gen 1, collectively referred to as "USB 3"), and using lower versions such as USB 2.0 and 1.1 may result in lower performances due to interface limitations inherent in such lower versions. * Performance may vary depending on user's system to which T5 is connected. Even when using USB 3.0 connections, T5 may not perform well if your system does not support UASP (USB Attached SCSI Protocol). Please make sure that your system supports UASP. 2. Recommended Operating Systems for Using Security Software To enjoy security software for T5, we recommend the operating system ("OS") meeting the following requirements: • Windows OS: Windows 7 or higher • Mac OS: Mac OS X 10.9 or higher • Android: Android KitKat (ver. 4.4) or higher 3. File Formats T5 is pre-formatted in using exFAT file system which is supported by Windows OS, Mac OS, and Android operating systems. Whether data formatted to a certain format may be read or written to your computer vary depending on the OS, as specified in the table below. If you use T5 on a single OS, it is recommended that you format the T5 using the appropriate file format for that OS. (e.g.) Read/write restrictions for file systems by each operating system File Formats Windows OS Mac OS exFAT Both read and write Both read and write NTFS Both read and write Read only HFS Not recognizable Both read and write * When using exFAT across multiple operating systems, data writing may become locked and you may only be able to read data. If such problem occurs, you can restore write access by following the instructions below. • Mac OS: Connect T5 to your Mac again, and perform Eject. • Windows OS: When the notice pops up saying that write access is disabled, click "Scan and fix" to perform Check Disk (CHKDSK). If you did shut down the notice without performing Check Disk, you may do it by selecting the drive → Right-click → Properties → Tools → click Check. 3