Samsung NA24T4230FS/AA User Manual - Page 11
Using the cooktop burners, Ignition
View all Samsung NA24T4230FS/AA manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 11 highlights
Using the cooktop burners Ignition Make sure all cooktop burners are properly installed. To light a burner: 2 1. Fully press down the control knob for the corresponding cooking position and turn it to the left, to the Lite position, 1 and hold it here for a few seconds at most until the burner ignites. After igniting, keep the control knob 2. pressed for about 5-8 seconds more because the heat sensor that opens the gas channel has to warm up first. Set control knob to the position you want. Repeat steps 1 and 2 to check the 3. operation of each cooktop burner in succession. The flame size can be set continuously 4. between maximum and minimum by slowing turning the control knob. Manual ignition If there is a power failure, you can ignite the burner manually. Use caution when doing this. 1. Hold a long gas grill lighter to the cooktop burner you want to light. 2. Push in the control knob for that burner, and then turn it to the Lite position. Turn on the grill lighter to ignite the burner. 3. After the burner is lit, turn the control knob to adjust the flame level. Flame level The flames on the burners should always stay under the cookware, and should not extend beyond the cookware bottom at any time. WARNING • Flames larger than the cookware bottom may result in a fire or physical injury. • When you set a burner to simmer, do not turn the burner knob quickly. Watch the flame to make sure it stays on. • After turning on a surface burner, make sure that the burner is ignited. Adjust the level of the flame by turning the burner knob. • Always turn off the surface burner controls before removing cookware. All surface burner controls should be turned OFF when you are not cooking. • Always turn the burners off before you go to sleep or go out. • If you smell gas, turn off the gas to the cooktop and call a qualified service technician. NEVER use an open flame to locate a leak. • If you turn the knob, but the surface burner does not ignite, turn off the control knob immediately. • Do not operate the burner for an extended period of time without cookware on the grate. The finish on the grate may chip without cookware to absorb the heat. • Be sure the burners and grates are cool before you place your hand, a pot holder, cleaning cloths or other materials on them. Using the cooktop burners English 11