Samsung NE63T8911SG/AA User Manual - Page 60
Troubleshooting, English, Problem, Possible cause, Solution
View all Samsung NE63T8911SG/AA manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 60 highlights
Troubleshooting Troubleshooting Samsung works hard to ensure that you don't have problems with your new electric range. If you run into unexpected trouble, look first for a solution in the tables below. If you're still having trouble after trying the suggested solution, call Samsung at 1-800-SAMSUNG (1-800-726-7864). Installation Problem The range is not level. The appliance must be accessed for servicing and cannot be moved easily. Possible cause Solution The appliance has been installed improperly. • Place the oven rack in the center of the oven. Place a level on the oven rack. Adjust the leveling legs at the base of the range until the oven rack is level. • Insure the floor is level and strong and stable enough to adequately support the range. The floor is sagging or sloping. Contact a carpenter to correct the situation. The kitchen cabinets are not properly aligned and make the range appear to be not level. Insure the cabinets are square and provide sufficient room for installation. The kitchen cabinets are not Contact a builder or square and too close to the installer to make the appliance. appliance accessible. Carpet is interfering with movement of the range. Provide sufficient space so the range can be lifted over the carpet. CONTROL DISPLAY Problem The display goes blank. The display flashes. Possible cause A fuse in your home may be blown or the circuit breaker tripped. There was a power failure. Solution Replace the fuse or reset the circuit breaker. Reset the clock. COOKTOP Problem Possible cause Solution The surface units will not maintain a rolling boil or will not cook fast enough. You may be using inappropriate cookware. In some areas, the power (voltage) may be low. Use pans that are flat and match the diameter of the surface unit selected. Cover the pan with a lid until the desired heat is obtained. The surface units will not turn on. A fuse in your home may be blown or a circuit breaker may have tripped. Replace the fuse or reset the circuit breaker. The cooktop controls are set Check if the correct control improperly. is set for the surface unit you are using. Areas of Food spillover was not discoloration on the cleaned. cooktop. Refer to the section on the care and cleaning of the glass cooktop on page 55. The surface is hot and the model features a lightcolored cooktop. This is normal. The surface may appear discolored when it is hot. This is temporary and will disappear as the glass cools. Troubleshooting 60 English