Samsung RF263BEAESR User Manual Ver.1.0 (English, French, Spanish) - Page 15

02 operating Fridge button to set your desired temperature. After a few seconds, the Fridge will begin adjusting towards the newly set temperature. This will be reflected in the digital display. Using the ice Dispenser Place a glass underneath the ice dispenser and push gently against the dispenser lever with your glass. Make sure the glass is in line with the dispenser to prevent the ice from bouncing out. Please wait 2 seconds before removing the caution glass under the dispenser to prevent spills. If the Refrigerator door opens, the Dispenser does not work. Recommend Temp (Fridge) : 37°F (or 3°C ) -- The temperature of the Freezer, Fridge or Cool Select Pantry Zone may rise when you open the doors too frequently, or if a large amount of warm or hot food is placed inside. -- This may cause the digital display to blink. Once the Freezer and Fridge temperature return to their normal set temperatures, the blinking will stop. -- If the blinking continues, you may need to "reset" the Refrigerator. Try unplugging the appliance, wait for around 10 minutes and then plug the power cord back in. -- If there is a communication error between the Display and Main Controller, the Convertible Display light may blink. If the blinking continues for a long period of time, please contact a Samsung Electronics Service Center. uSING ThE cOld WATER dISpENSER Push the appropriate ice type button to select what you want dispensed. NO ICE Select this if you want to turn ice maker off When Cubed Ice is selected after using caution the Crushed Ice mode, a small amount of residual crushed ice might be produced. Do not pull the lever out. You could damage caution or break the lever's spring. check the water level Test button •• To clean the ice bin/bucket, wash with a mild detergent, rinse well, and dry thoroughly it. Do not use harsh or abrasive cleaners or solvents. •• When you select Cubed Ice after using the Crushed Ice mode, a small amount of residual crushed ice might be produced. •• The ice cubes generated by the rapid ice making process will look white, which indicates they are generated normally. •• As the ice maker in the refrigerator room makes ice cubes even faster, move the ice cubes from the refrigerator ice bin to the freezer ice bin if you need more ice cubes. •• If ice doesn't come out, pull out the ice bucket and press the test button located on the right side of ice maker. •• Do not press the test button continuously when the tray is filled with ice or water. Water may overflow or ice may jam the bucket. •• Normal Use To fill the ice bucket to maximum capacity after installation, follow these steps: Water may overflow or ice may jam the bucket. operating _15 DA68-02601A(EN+FR+ES)-0.2.indb 15 2012.3.31 9:49:48 AM