Samsung RF266AASH/XAA User Manual (user Manual) (ver.0.3) (English) - Page 18
Removing any residual matter inside the water, supply line after installing the water filter. - problems
View all Samsung RF266AASH/XAA manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 18 highlights
Setting up your French Door Refrigerator 4. Remove the filter cap and insert the filter into the filter housing. 5. Slowly turn the water filter 90º clockwise to align with the printing mark on the cover, locking the filter in position. Make sure to align the water filter label mark with center of cover filter printing as illustrated. Remember, do not overtighten. Separation of red cap. Cover filter. Turn until the label aligned. You should remove the right side upper glass shelf before installing water filters. Removing any residual matter inside the water supply line after installing the water filter. 1. Turn ON the main water supply & turn OFF the valve to the water supply line. 2. Run water through the dispenser until the water runs clear (approx. 6-7 minutes). This will clean the water supply system and remove air from the lines. 3. Additional flushing may be required in some households. 4. Open the Refrigerator door and make sure there are no water leaks coming from the water filter. /NE4OUCH0URE7ATER Be sure to flush the dispenser thoroughly or water may drip from the dispenser. This is due to the fact that there is still air in the line. Check the amount of water supplied to the ice tray. 1. When you press the TEST button, the ice cube container is filled with water from the water supply tap. Check to make sure the amount of water is correct (see the illustration below). If the water level is too low, the ice cubes will be small. This is a water pressure problem of the main water pipes, not the Refrigerator. If this problem occurs, contact the dealer service center for help. Feeler Arm 1_ Setting Up Check the water level test button