Samsung RS25H5111SR User Manual Ver.1.0 (English) - Page 16
Installing The Water, Dispenser Line - lowe s
View all Samsung RS25H5111SR manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 16 highlights
INSTALLING THE WATER DISPENSER LINE A water dispenser is one of the helpful features on your new Samsung Refrigerator. To help promote better health, the Samsung water filter removes unwanted particles from your water. However, it does not sterilize or destroy microorganisms. You may need to purchase a water purifying system to do that. The water line also connects to the ice maker. For the ice maker to operate properly, water pressure of 20 ~ 125 psi (138 ~ 862 kPa) is required. If the refrigerator is installed in an area with low water pressure (below 20 psi), you can install a booster pump to compensate for the low pressure. After you have connected the water line, make sure the water storage tank inside the refrigerator is properly filled. To do this, press the water dispenser lever until water runs from the water dispenser. Water line installation kits are available at extra cost from your dealer. We recommend using a water supply kit that contains copper tubing. Connecting to the water supply line 1. First, shut off the main water supply line and turn the ice-maker off. Connecting the water supply line to the refrigerator There are several items that you need to purchase to complete this connection. You may find these items sold as a kit at your local hardware store. Use Copper Tubing • ¼" copper tubing • ¼" compression nut (1pc) • Ferrule (2pc) Use Plastic Tubing • ¼" plastic tubing → Molded end (Bulb) • ¼" compression nut (1pc) Refrigerator Compression Nut (1/4") (Assembled) Plastic Tubing (Supplied) Compression Fitting (Assembled) Ferrule (Not supplied) Bulb Compression nut (B) (1/4") (Not supplied) Copper tubing or Plastic tubing (B) (Not supplied) (Not supplied) Household water line The refrigerator should NOT be plugged in at this point. 2. Locate the nearest cold water drinking water line. 3. Install the pipe clamp and shut off valve. 4. Connect the water line installation kit to the shut off valve. Cold water line Pipe clamp Shut off valve Water line installation kit 1. Connect the household water line to the assembled compression fitting. -- If you are using copper tubing, slip the compression nut ( B ) (not supplied) and ferrule (not supplied) on the copper tubing (not supplied) as shown. -- If you are using plastic tubing ( B ), insert the molded end (Bulb) of the plastic tubing ( B ) into the compression fitting. CAUTION Do not use plastic tubing ( B ) without the molded end (Bulb). English - 16 DA68-02981E-01.indb 16 14. 1. 20. �� 7:48