Samsung SCX 6322DN Service Manual - Page 52

Alignment & Adjustments 4.7 Error Messages Message Authentication Failure Cancel? Yes [COMM. Error] Connection Error Connection Failed [Document Jam] Door Open Drum Warning Enter Again Duplex Jam Open/Close Door File Access Denied File Name Exist File Name Over Limit Fuser Door Open Group Not Available [Incompatible] Invalid Server Address Line Busy Meaning Suggested solutions The ID or password you entered is incorrect. Your machine's memory has become full while trying to store an original into memory. The machine has a communication problem. Connection with the SMTP server failed. The protocol you have entered is not supported or server port is wrong. The loaded original has jammed in the ADF. The front cover or rear cover is not securely latched. The drum cartridge is near the end of its life. You entered an unavailable item. Paper has jammed during duplex printing. Enter the correct ID or password. To cancel the fax job, press the OK button to accept Yes. If you want to send those pages that have been successfully stored, press the OK button to accept No. You should send the remaining pages later, when memory is available. Ask the sender to try again. Check the server settings and the network cable. Check the protocol or server port. Clear the jam. Close the cover until it locks into place. You should ensure a replacement cartridge in stock. Enter the correct item again. Clear the jam. Login to the network server was successful. However, access to the file on the network server was denied. The file name you have entered already exists. The file names you can use are from doc001 to doc999. However, all file names are used already. The fuser door is not securely latched. You have tried to select a group location number where only a single location number can be used, such as when adding locations for a Multiple Send operation. The machine has received a fax from which is registered as a junk fax. The server address you have entered is invalid. The receiving fax machine did not answer or the line is already engaged. Change the server settings. Enter a different file name. Delete unnecessary files. Open the rear cover and close the fuser door until it locks into place. For the location of the fuser door. Use a speed dial number or dial a number manually using the number keypad. The received fax data will be deleted. Reconfirm junk fax setup. Enter the correct server address. Try again after a few minutes. Samsung Electronics Service Manual 4-25