Samsung SCX 6322DN Service Manual - Page 53

Alignment & Adjustments Message [Line Error] Low Heat Error Cycle Power LSU Motor Error Cycle Power LSU Hsync Error Cycle Power Main Motor Locked Mail Exceeds Server Support Memory Full MP Tray Paper Empty Network Error [No Answer] Not Assigned [No Paper] Add Paper One Page is Too Large Open Heat Error Cycle Power Operation Not Assigned Over Heat Error Cycle Power Paper Jam 0 Open/Close Door Paper Jam 1 Open/Close Door Paper Jam 2 Check Inside Power Failure Meaning Your machine cannot connect with the receiving fax machine or has lost contact because of a problem with the phone line. There is a problem in the fuser unit. A problem has occurred in the LSU (Laser Scanning Unit). A problem has occurred in the LSU (Laser Scanning Unit). There is a problem in the main motor. The mail size is larger than the supported size by SMTP server. The memory is full. There is no paper in the multi-purpose tray. Suggested solutions Try again. If the problem persists, wait an hour or so for the line to clear and try again. Or, turn the ECM mode on. Unplug the power cord and plug it back in. If the problem persists, Replace to the Fuser Unit Unplug the power cord and plug it back inches. If the problem persists, Replace to the Fuser Unit Unplug the power cord and plug it back inches. If the problem persists, Replace to the Fuser Unit Open and then close the front cover. Divide your mail or reduce the resolution. Delete unnecessary fax jobs and retransmit after more memory becomes available. Alternatively, split the transmission into more than one operation. Load paper in the multi-purpose tray. There is a problem with the network. The receiving fax machine has not answered after several redial attempts. The one-touch dial or speed dial number you tried to use has no number or email address assigned to it. The paper in the tray has run out. Single page data exceeds the configured mail size. There is a problem in the fuser unit. You are in the Add Page/Cancel Job operation, but there are no jobs stored. There is a problem in the fuser unit. Paper has jammed in the feeding area of the tray. Paper has jammed in the fuser area. Contact your network administrator. Try again. Make sure that the receiving machine is operational. Enter the number or email address manually using the number keypad or store the number or address. Load paper in the tray. Reduce the resolution and try again. Unplug the power cord and plug it back in. If the problem persists, Replace to the Fuser Unit Check the display to see if there are any scheduled jobs. Unplug the power cord and plug it back in. If the problem persists, Replace to the Fuser Unit Clear the jam. Clear the jam. Paper has jammed in the paper exit area. Clear the jam. Power has turned off then on and the machine's memory has not been back up. The job which you were trying to do before the power failure must be completely re-done. 4-26 Service Manual Samsung Electronics