Sanyo CE42LH2WP Owner's Manual - Page 27

BB AA

Get Sanyo CE42LH2WP - 16:9 PDF manuals and user guides
UPC - 086483077777
View all Sanyo CE42LH2WP manuals
Add to My Manuals
Save this manual to your list of manuals

Page 27 highlights

INSTALLING POSITION When the monitor installed outside, it SHOULD NOT set in a position where the screen is subjected to direct sun light. If it can't be done, please prepare adequate shading. Direct sun light can cause the screen surface temperature WRULVHDERYHWKHPD[LPXPRSHUDWLQJUDQJH This causes a black shadow to appear on the screen, which will disappear when the screen temperature returns WRZLWKLQVSHFLÀFDWLRQ English WIRE ASSEMBLY 1. Connect the in-line waterproof AC cord, line up and push together connectors A & B so they are tight and then twist C until A & B cannot be pulled apart. To disconnect unscrew C and pull connector A & B apart. To Connect To Disconnect A B C C A B 2. Remove the covers A for access to connect required cables. Re-position the covers and replace screws. If LD Net connection is required remove cover B and connect cable, then re-position cover B and replace screws. B B A A DO NOT REMOVE SILICA GEL SACHETS FROM INSIDE LD-NET TERMINAL COVER (B) AND TERMINAL COVER (A). Thank you for your attention. We hope our Weatherproof monitors are to your satisfaction. 7

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
7
English
Thank you for your attention.
We hope our Weatherproof monitors are to your satisfaction.
When the monitor installed outside, it
SHOULD NOT
set
in a position where the screen is subjected to direct sun
light.
If it can’t be done, please prepare adequate shading. Di-
rect sun light can cause the screen surface temperature
This causes a black shadow to appear on the screen,
which will disappear when the screen temperature returns
1.
Connect the in-line waterproof AC cord, line up and push together connectors A & B so they are
tight and then twist C until A & B cannot be pulled apart. To disconnect unscrew C and pull con-
nector A & B apart.
2.
Remove the covers
A
for access to connect required cables. Re-position the covers and replace
screws.
If LD Net connection is required remove cover
B
and connect cable, then re-position cover
B
and
replace screws.
INSTALLING POSITION
WIRE ASSEMBLY
B
A
B
A
A
B
C
A
B
C
DO NOT REMOVE SILICA GEL SACHETS FROM INSIDE LD-NET TERMINAL COVER (B)
AND TERMINAL COVER (A).
To Connect
To Disconnect