Sanyo EM-Z2100GS Owners Manual - Page 9

SET UP 25941_EM_Z2100GS manual.qxd 7/7/05 8:32 AM Page 9 INSTALLATION Remove all packing material and accessories. Examine the oven for any damage such as dents or broken door. Do not install if oven is damaged. NOTE: This unit is not designed for 50 Hz or any circuit other than a 120-volt/ 60-Hz AC circuit. This oven is designed for countertop installation. Countertop Installation 1. Select a level surface that provides enough open space for the intake and/or outlet vents. Minimum clearances required between the oven and any adjacent walls are shown above. • Leave a minimum clearance of 8 inches above the oven. • Do not remove the legs from the bottom of the oven. • Blocking the intake and/or outlet openings can damage the oven. • Place the oven as far away from radios and TV's as possible. Operation of microwave oven may cause interference to your radio or TV. • If the cabinet is covered with a protective film, remove the film. 2. Plug your oven into a standard 120-volt / 60-Hz household outlet. Be sure the electrical circuit is at least 15 amperes and that your microwave oven is the only appliance on the circuit. WARNING: Do not install oven over a range cooktop or other heat-producing appliance. If installed near or over a heat source, the oven could be damaged and the warranty would be void. 9