Sanyo ET30L Instruction Manual, PLC-ET30L - Page 68
Indicators and Projector Condition, Indicators, Appendix
UPC - 086483069925
View all Sanyo ET30L manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 68 highlights
Appendix Indicators and Projector Condition Check the indicators for the projector condition. WARNING TEMP. indicator Indicators POWER green LAMP red WARNING TEMP. red Projector Condition The projector is off. (The AC power cord is unplugged.) The projector is in stand-by mode. Press the ON/STAND-BY button to turn on the projector. The projector is operating normally. POWER, LAMP, WARNING TEMP., WARNING FILTER, and LAMP REPLACE indicators are blinking all together. The projector is in the Power management mode. The projector is preparing for stand-by or the projection lamp is being cooled down. The projector cannot be turned on until cooling is completed and the POWER indicator stops blinking. The WARNING TEMP. indicator blinks slow when the temperature inside the projector is elevated close to the abnormally high level. The temperature inside the projector is abnormally high. The projector cannot be turned on. When the projector is cooled down enough and the temperature returns to normal, the POWER indicator stops blinking and the projector can be turned on. (The WARNING TEMP. indicator keeps blinking.) Check and clean the filter. The projector has been cooled down enough and the temperature returns to normal. When turning on the projector, the WARNING TEMP. indicator stops blinking. Check and clean the filter. The projector detects an abnormal condition and cannot be turned on. Unplug the AC power cord and plug it again to turn on the projector. If the projector is turned off again, unplug the AC power cord and contact the dealer or the service center. Do not leave the projector on. It may cause an electric shock or a fire hazard. • • • lighting • • • blinking • • • off 68