Sanyo FW40D48F Owners Manual - Page 34
Useful tips, FAQ
View all Sanyo FW40D48F manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 34 highlights
6 Useful tips 34 .English FAQ Question Answer My remote control does not work. What should I do? ● Check the antenna or cable connection to the main unit. ● Check the batteries on the remote control. ● Re-insert or replace the AAA batteries with their polarities (+/-) as indicated on the remote control battery area. ● Check if there is an obstacle between the infrared sensor window and the remote control. ● Test the IR signal output use IR signal check. L p. 36 If okay, then possible infrared sensor trouble. ● Aim the remote control directly at the infrared sensor window on the front of the unit. ● Reduce the distance to the unit. ● When there is an infrared-equipped device such as PC near this unit, it may interrupt the remote control signal on this unit. Move the infrared-equipped device away from this unit, change the angle of the device's infrared sensor or turn off the infrared communication function. How come the initial setup appears every time I turn on this unit? ● Connect the RF coaxial cable directly to this unit and run the initial setup. ● Make sure to complete the initial setup before the unit goes into standby mode. ● Autoprogram must be completed when you set up the unit for the first time or move it to a location where previously unavailable channels are broadcast. ● Make sure Autoprogram has been completed. L p. 23 ● The selected channel may not be broadcasting. Why can I not watch some RF signal TV ● When Autoprogram is interrupted and not completed, some channels will not be received. Make programs? sure to complete the Autoprogram. L p. 23 ● The selected channel cannot be viewed by the Child and ratings lock setting. L p. 26 ● The unit requires some kind of antenna input. An indoor antenna (Digital or VHF / UHF), an external antenna (Digital or VHF / UHF) or an RF coaxial cable from your wall cable or set-top box needs to be plugged into the unit. How come there is no image from the connected external devices? ● Check if the correct input mode is selected by pressing SOURCE or using CH + / -. Refer to Watching channels from an external device L p. 17 ● Check the antenna, cable or other input connection to the unit. ● When using the component video connection check that the green (Y), blue (Pb/Cb) and red (Pr/Cr) connectors are connected to their corresponding colored jacks on the unit. When I enter a channel number, why does it change automatically? ● Many digital channels have alternate channel numbers. The unit changes the numbers automatically to the ones signifying the broadcasting station's channel number. These basic numbers used for the previous analog broadcasts. (e.g., input digital ch# 30 automatically changes to digital ch# 8.1) Why are captions not displayed entirely? Or why are captions delayed behind the dialog? ● Closed captions that are delayed a few seconds behind the actual dialog are common for live broadcasts. Most captioning production companies can display a dialog to maximum of 220 words per minute. If a dialog exceeds that rate, selective editing is used to insure that the closed captions remain up-to date with the current TV screen dialog. How can I set the clock? ● There is no clock function on this unit. My PIN code no longer works, how can ● If a Power failure occurs for longer than 10 seconds the child lock setting is retained, but the PIN I change the child lock setting? code is reset to the default code 0000. Refer to Child and ratings lock. L p. 26 Continued on next page.