Sanyo FWDP175F Owners Manual - Page 17

A System Setting You can change the Display functions. Follow steps 1 and 2 on page 16. 3 Select the desired item. 4 Voice Guide: (Default: On) Turns On/Off the Voice Guide function. 5 To Exit the Menu SYSTEM LANGUAGE AUDIO VIDEO OTHER Voice Guide TV Aspect Resolution HDMI CEC On Off ENTER Voice Guide On TV Aspect Off Resolution HDMI CEC Select the Desired Setting. TV Aspect: (Default: 16:9 Widescreen) Sets the aspect ratio of the playback image to fit your TV. See the note on the right. Voice Guide TV Aspect Resolution HDMI CEC 4:3 Pan & Scan 4:3 Letterbox 16:9 Widescreen 16:9 Squeeze Note(s): Voice Guide: • In order to enable the Voice Guide function, the OSD language needs to be set to English. Voice Guide is not available in French or Spanish. • "Audio Out" cannot be configured when Voice Guide is set to On, as it is fixed to PCM. In order to configure the setting, set Voice Guide to Off. Resolution: (Default: Auto) You can select the desired "Resolution" among the settings. See the note on the right. Voice Guide TV Aspect Resolution HDMI CEC Auto 480P 720P 1080i 1080P HDMI CEC: (Default: On) HDMI CEC allows integrated system control over HDMI. See the note below. Voice Guide On TV Aspect Off Resolution HDMI CEC TV Aspect: • Select "4:3 Pan & Scan" for a full height picture with both sides adjusted. • Select "4:3 Letterbox", black bars may appear on the top and bottom of the TV screen. • Select "16:9 Widescreen" if a wide-screen TV is connected to this unit. • Select "16:9 Squeeze" to display 4:3 aspect ratio in the center of the 16:9 screen when playing back 4:3 images. Resolution: --Auto: HDMI video resolution will be selected automatically depending on the connected HDMI device. • When you make a selection, the TV monitor temporarily goes blank and then comes back again. If it does not, press and hold [ BF (PLAY / PAUSE) ] on the front panel for 5 seconds to change the setting of the resolution back to its default. Note: HDMI CEC: • HDMI CEC allows integrated system control over HDMI and is part of the HDMI standard. This function may not work properly depending on the device connected to the unit. When "HDMI CEC" setting is set to "On" the functions listed below will be available. COne Touch Play When the buttons below on the remote control are pressed then operations are performed on this unit, the TV will automatically be turned on and switched to the appropriate video input. Buttons for one touch play: - [PLAY B], [SKIP H , G], [DISPLAY], [SETUP] - [TOP MENU], or [MENU] (when a disc is inserted in the unit) COne Touch Standby When you press and hold [POWER] for 2 seconds, it turns off the TV first and then turns off this unit. When the connected fun-Link (HDMI CEC) compatible display device is turned off first, it then turns off the power to this unit. C System Information Get & Set Menu Language The unit recognizes the OSD language set on the TV and automatically sets the same language as the on-screen language in "Menu" setting. Feature is available only when "Menu" in "LANGUAGE" menu is set to "Auto" while connected via an HDMI cable. EN - 17 -