Sanyo FWSB405F-A Owners Manual - Page 4

Disconnect the mains (AC) plug to shut off when find trouble or not in use. The mains (AC) plug shall remain readily operable. CAN ICES-3 (B)/NMB-3 (B) This device complies with Industry Canada's applicable licence-exempt RSSs. Operation is subject to the following two conditions: (1) This device may not cause interference; and (2) This device must accept any interference, including interference that may cause undesired operation of the device. CAUTION: Danger of explosion if battery is incorrectly replaced. Replace only with the same or equivalent type. WARNING: Batteries (Battery pack or battery installed) shall not be exposed to excessive heat such as sunshine, fire or the like. Do not place the unit on the furniture that is capable of being tilted by a child and an adult leaning, pulling, standing or climbing on it. A falling unit can cause serious injury or even death. In order to avoid interruption of ventilation, this unit should not be placed in built-in equipment such as a book cabinet, rack, etc., and the vents of this unit should not be covered with anything such as a tablecloth, curtain, newspaper, etc. Make sure to leave a space of 4 inches (10 cm) or more around this apparatus. Never use a gas duster on this unit. The gas trapped inside of this unit may cause ignition and explosion. This transmitter must not be co-located or operated in conjunction with any other antenna or transmitter. When installing this unit in a temperate environment, avoid a place with rapid temperature changes. This unit should not be used in a tropical environment as it has not been evaluated under such conditions. No objects should be placed directly on or under this unit, especially lighted candles or other flaming objects. Disposal of used batteries The batteries included do not contain the heavy metals mercury and cadmium, however in certain localities, disposing batteries with household waste is not permitted. Please ensure you dispose of batteries according to local regulations. Mounting soundbar on a wall • The recommended screw (sold separately) allows the mounting of the soundbar on the wall. • Funai is not liable for any accident, damage or injury due to any improper installation, lack of strength of installation or improper use. • Drill screw holes into the wall. Depending on the wall material, use molly anchor inserts to make sure the screws will not fall out. Although the soundbar weighs approximately 5.3 lb/2.4 kg, it is recommended that the wall be able to support 15.9 lb/ 7.2 kg (three times the weight of the soundbar) for extra safety. Recommended measurements are as follows: wall thickness of 2"/5 cm or more, screw diameter of 5/32"/4 mm and, screw length of 1-3/16"/30 mm or more. • Screw and molly anchor are sold separately and are not included. Funai is not liable for these types kinds of accidents or injury noted below. • Install two screws on a sturdy vertical wall. • If installed onto a ceiling or slanted wall, the soundbar and screws may fall which could result in a severe injury. • Do not use screws that are longer or shorter than their specified length. If screws too long or short are used this may cause the soundbar to fall. • Do not fasten screw's and molly anchor's with excessive force, this may damage the wall causing the soundbar to fall, leading to an injury. • Do not mount the soundbar onto screws while the soundbar is plugged in or turned on. It may result in an electrical shock injury. When installing the soundbar on a wall, allow this much space. Top: 4"/10 cm Bottom: 4"/10 cm Left and right sides: 4"/10 cm Space between mounting screw and wall: 9/64"- 5/32"/3.5 - 4 mm To Avoid the hazards of electrical shock and fire • Do not handle the AC power cord with wet hands. • Do not pull on the AC power cord when disconnecting it from an AC outlet. Grasp it by the plug. • Do not put your fingers or objects into the unit. Location and handling • Do not install the unit in direct sunlight, near strong magnetic fields, or in a place subject to dust or strong vibration. • Avoid a place with drastic temperature changes. • Install the unit in a horizontal and stable position. Do not place anything directly on top or bottom of the unit. Depending on your external devices, noise or disturbance of the picture and / or sound may be generated if the unit is placed too close to them. In this case, please ensure enough space between the external devices and the unit. • Depending on the environment, the temperature of this unit may increase slightly. This is not a malfunction. • Be sure to Unplug the AC power cord from the AC outlet before removing the unit. Dew condensation warning • Dew condensation may form inside the unit in the following conditions. If so, do not use this unit at least for a few hours until its inside gets dry. -- The unit is moved from a cold place to a warm place. -- Under conditions of high humidity. -- After heating a cold room. Note about recycling • This unit's packaging materials are recyclable and can be reused. Please dispose of any materials in accordance with your local recycling regulations. • Batteries should never be thrown away or incinerated but disposed of in accordance with your local regulations concerning chemical wastes. • For product recycling information, please visit www.sanyo-av.com Click on EN - 4 -