Sanyo FWSB405F-A Owners Manual - Page 7

Remote control Installing the batteries for the remote control Install 2 AAA (1.5V) batteries matching the polarity indicated inside battery compartment of the remote control. 1 2 3 • The maximum operable ranges from the unit are as follows. -- Line of sight: approx. 23 feet (7m) -- Either side of the center: approx. 16 feet (5m) within 30° -- Above: approx. 16 feet (5m) within 15° -- Below: approx. 10 feet (3m) within 30° NOTE(S) • Do not mix alkaline, standard (carbon-zinc), or rechargeable (ni-cad, ni-mh, Li-ion, etc) batteries. • Do not mix old and new batteries. • Always remove batteries from the remote control if they are dead or if the remote control is not to be used for an extended period of time. This will prevent battery acid from leaking into the battery compartment. Operating with the remote control 1 8 2 9 3 10 4 5 6 7 11 12 Buttons 1 Description Press to turn on the unit, or to switch the unit into standby mode. (To completely turn off the unit, you must unplug the AC power cord.) 2 Press to switch to the standard preset sound. 3 Press to switch to the preset sound for music. Press to mute the sound and press again to 4 unmute the sound. Press to select optical input of the connected 5 device to this soundbar. 6 Press to select line input of a connected device to this soundbar. Press to select auxiliary input of a connected 7 device to this soundbar. Press to adjust volume up / down on the 8 soundbar. Press to switch to the preset sound for a 9 movie. Press to switch to the preset sound for news 10 scene. Press to select Bluetooth signal of a connected 11 device to this soundbar. Press to disconnect the currently connected Bluetooth compatible device and start pairing mode to establish a new connection to another Bluetooth compatible device. 12 If no Bluetooth compatible device is connected within 2 minutes, press this button to restart pairing mode. Pairing mode can only be started when Bluetooth is selected. EN - 7 -