Sanyo FWSB415E Owners Manual - Page 10

4 Connect and set up This section helps you connect your SoundBar to a TV and other devices, and then set it up. For information about the basic connections of your SoundBar and accessories, see the quick start guide. Note •• For identification and supply ratings, see the type plate at the back or bottom of the product. •• Before you make or change any connections, make sure that all devices are disconnected from the power outlet. 4.1 Position the SoundBar Place the subwoofer at least 1 meter (3 feet) away from your SoundBar, and ten centimeters away from the wall. For best results, place your subwoofer as shown below. 10cm/4" 1m/3ft 4.2 Wall mount the SoundBar(optional) Use screws (not supplied) that are suitable for the wall material and strength. As a plaster board wall is especially fragile, attach the screws securely to a wall beam. 1) Drill two holes on the wall. 2) Secure the dowels and screws in the holes. 3) Hang the SoundBar on the fastening screws. ~240mm/9.25" 3.5-4mm/0.14"-0.16" 4mm/ 0.16" >25mm/0.98" ~5mm/0.2" ~9mm/0.35" Warning •• Improper wall mounting may result in accident, injury or damage. If you have any query, contact Consumer Care in your country. •• Before wall mounting, make sure the wall can support the weight of your SoundBar. •• SANYO is not liable for improper wall mounting that result in accident, injury or damage. •• Install the Soundbar on the sturdy vertical wall. •• Do not install the Soundbar onto a ceiling or slanted wall, it may easy to fall down and result in severe injury. •• Do not use the screws that are shorter than the specified length, it may cause the Soundbar to fall down easily. •• Do not mount the Soundbar on a wall while the Soundbar is plugged in or turned on, it may result in an electrical shock injury. 8 EN