Sanyo FXCD-1350 Owners Manual - Page 29

Notes • When using a two-speaker installation, the Green, Green/Black, Violet, Violet/Black wires, which are used for a four-speaker installation, are not used. The ends of these wires must be covered with electrical tape to prevent them from shorting to the unit or the vehicle chassis. • When using a two-speaker installation, set the FADER control to the center position. • When fuse replacement is necessary remove the blown fuse by using pliers. Then install the new 15 amp. fuse. Fuse 15A NG OK Burnt LINE OUT/CD CHANGER CONNECTIONS • The unit has a built-in CD changer controller and line output terminals. You can use a compatible Sanyo CD changer and a separate amplifier to upgrade your system. CD Changer DIN Socket RCA Line-out Jacks OUTPUT FRONT REAR White L (eft) R (ight) Red External Amplifier CD Changer Rear Speaker Front Speaker CD Changer DIN Socket • Connect the 8-pin DIN cable, which is supplied with the compatible Sanyo CD changer, to the DIN socket on the back of the unit. RCA Line-out Jacks (For Speakers) • Connect a patch cable (not supplied) from the White (left channel) and Red (right channel) RCA line output jacks to the line input terminals of the external amplifier. -28-