Sanyo FXCD-1350 Owners Manual - Page 7

BATTERY INSTALLATION Install a lithium battery (CR2025) with the poles facing the correct direction. Positive pole faces upward. BATTERY REPLACEMENT TIMING When battery power is depleted, the buttons may not be operable. If the remote controller does not operate, replace the battery and check the operation. CAUTIONS REGARDING BATTERY Be sure to follow the instructions to prevent battery leakage, over-heating, ignition, or explosion. WARNING • Do not expose the battery to flame. Do not short circuit, disassemble, or heat the battery. • Do not charge the battery. • Use the specified type battery. • Keep the button-shaped battery away from children to prevent accidental swallowing. • If the battery is swallowed, contact a doctor immediately. CAUTION • Install the battery with the poles facing the correct direction. • When not in use for a long period of time, or if the battery is dead, remove the battery from the remote controller. If battery leakage has occurred, wipe the container first, then install a new battery. If the battery solution contacts the skin, wash off with water completely. CAUTIONS REGARDING REMOTE CONTROLLER • Do not leave the remote controller in an area exposed to direct sunlight, such as on the dashboard or steering wheel. The remote controller may deform because of the heat. (Be especially careful of the dashboard exposed to direct sunlight in the summer, as it will become extremely hot.) • When the vehicle is parked in an area exposed to direct sunlight, remove the remote controller from its holder and put it in a shaded spot such as the glove box. • Under direct sunlight, signal reception from the remote controller becomes weakens. If this happens, hold the remote controller close to the signal receptor on the front panel. -6-