Sanyo HEC-DR7700BR HEC-DR7700 Owners Manual English - Page 14

ADJUSTING MASSAGE INTENSITY When the massage is too strong Use the massager after placing a towel, etc., on the back pad. Towel When the massage is too weak Flip the back pad to the rear. Take off the head cover from the back pad. Flip the back pad to the rear. Head cover Back pad Back pad Attach the head cover to the back rest. Head cover 25 Hook-and-loop fastener Back rest AFTER USE CAUTION After use, be sure to set the POWER switch to the [OFF] position, and the LOCK switch to the [LOCK] position. When the equipment will not be used for an extended period, be sure to disconnect the power plug from the outlet. 1 Set the back rest and the foot rest to the starting position. 2 Turn off the POWER. When the display part When the foot rest is extended, return the foot rest to the home position by pulling the foot rest slide lever. Bring all parts of the massage chair to their home position by pressing the HOME POSITION button. of the remote control does not turn off, press the OERATION ON/OFF button. Close the cover of remote control. Put the remote control and the sensor controller Press LOCK switch Lower Be sure to check that there are no children, back on the stand. Coin pets, or any obstacles around the massager. Set the POWER switch to the [OFF] position, and the LOCK switch to the [LOCK] position Press using a coin. POWER switch MAINTENANCE PROCEDURES WARNING Be sure to disconnect the power plug from the outlet prior to maintenance. NOTE Do not attempt to use benzene, thinner, alcohol, alkaline detergent or bleaching agent for cleaning, as this may result in deformation, discoloration or cracking. Do not wash the head cover or the back pad. This may cause discoloration or deformation. HEAD COVER, BACK PAD, SEAT COVER, ARM REST Perform daily maintenance by wiping with a soft dry cloth. When they are badly soiled, adopt the following maintenance procedure: Soak a soft cloth in diluted neutral kitchen detergent, and squeeze it well. Wipe the main unit with the damp cloth in a tapping motion. Soak a cloth in clean water, and squeeze it well. Wipe off the remaining detergent with the damp cloth. Wipe it with a dry cloth afterwards. Do not force-dry with a drier. Do not make contact with vinyl products for an extended period. It may cause discoloration. MAIN UNIT (Plastic parts and frame) Soak a soft cloth in diluted neutral kitchen detergent, and squeeze it well. Wipe the main unit with the damp cloth, and wipe it with a dry cloth afterwards. REMOTE CONTROL, SENSOR CONTROLLER Wipe with a soft dry cloth. Do not wipe with a damp cloth. 26