Sanyo PLC-HF10000 Network Setup - Page 33

About projector condition

Get Sanyo PLC-HF10000 PDF manuals and user guides View all Sanyo PLC-HF10000 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 33 highlights

About projector condition Power control and status check Status Description Normal Projector is operating normally. Power management in operation........... Power management is operating Shutter management in operation....... Shutter management is operating Lamp failure Lamp failure is occurring Abnormal temperature The temperature of the projector became too high Standby after Abnormal Temp......... Projector detects abnormal temp. and sets into standby mode. Power failure Power failure has occurred inside the projector. Projector is turned off. Unplug the AC cord and ask servicing to a qualified service personnel. ENGLISH When a security (PIN code lock) has been set on the projector, you also cannot control it through the network. To control the projector through the network temporarily, execute "PJ lock suspend" command to unlock the security. "PJ lock suspend" is on setting sub menu [3] on Setting main menu. (+p.42) 33

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62
²²
ENGLISH
About projector condition
Status
Description
Normal
...............................................................
Projector is operating normally.
Power management in operation
...........
Power management is operating
Shutter
management in operation
......
Shutter management is operating
Lamp failure
...................................................
Lamp failure is occurring
Abnormal temperature
.........................
The temperature of the projector became too high
Standby after Abnormal Temp.
........
Projector detects abnormal temp. and sets into standby mode.
Power failure
................................................
Power failure has occurred inside the projector. Projector is turned
off. Unplug the AC cord and ask servicing to a qualified service
personnel.
Power control and status
check
When a security (PIN code lock) has been set on the projector, you also cannot
control it through the network. To control the projector through the network
temporarily, execute "PJ lock suspend" command to unlock the security. "PJ lock
suspend" is on setting sub menu [3] on Setting main menu. (
+
p.42)