Sanyo PLC-SW35 Owners Manual - Page 41

Setting Setting Power management For reducing power consumption as well as maintaining the lamp life, the Power Management function turns off the projection lamp when the input signal is interrupted and no button is pressed for a certain period. If the input signal is interrupted and no button is pressed for 30 seconds or more, the timer display with the message "No signal" appears on the screen. The count-down of the set time will get started. The count-down time can be set between 1 and 30 minutes. Set the count-down time with Point 7 8 button. When the count-down time has been elapsed, the lamp will be turned off to cool itself down. The POWER indicator is blinking red during this cooling-off period. The next operation depends on the setting as follows : Ready . . . . . .When the lamp has been fully cooled down, the POWER indicator changes to green blinking. In this condition, the projection lamp will be turned on if the input signal is reconnected or any button on the top control or remote control unit is pressed. Shutdown . . .When the lamp has been fully cooled down, the power will be turned off. Off The Power Management function is canceled. Power management Time left until Lamp off Press the SELECT button at Power management and this box appears. Choose one of three settings with the Point 7 8 button, and go to the timer with the Point ed button and set time with the Point 7 8 button. On start When this function is "On," the projector is automatically turned on just by connecting the AC power cord to a wall outlet. ✔Note: Be sure to turn the projector off properly (see "Turning Off the Projector" on page 18). If the projector is turned off in the wrong steps, the On start function does not operate properly. Lamp mode This function allows you to change brightness of the screen. Normal.........normal brightness Auto brightness according with the input signal Eco .......lower brightness reduces the lamp power consumption and extends the lamp life. 41