Sanyo PLC-XU4000 Owner's Manual - Page 57
Filter counter, 3000H/4000H/5000H/6000H
UPC - 086483079757
View all Sanyo PLC-XU4000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 57 highlights
Setting Fan control Choose the running speed of cooling fans from the following options according to the ground elevation under which you use the projector. Off Normal speed. Set this function to Off when using the projector in non-high altitude environment. On 1 Faster than Off mode. Select this mode when using the projector in high altitudes (about 1,200 meters or more above the sea level) where the fans have less cooling effect. On 2 Faster than On 1 mode. Select this mode when using the projector in higher altitudes than above where the fans have lesser cooling effect. Note: • The fan noise becomes louder in On 1 and On2. • Failure to set the running speed of cooling fans properly may affect the projector life. Video delay control When you want to make a digital processing of a projected image faster, set this function. Use the Point ▲▼ buttons, select an item of Off or On. Note: Noise reduction and Progressive can not be selected when Video delay control function is set to On. Filter counter This function is used to set a frequency for the filter replacement. Use the Point ▲▼ buttons to select Filter counter and then press the Point ► or the SELECT button to access the submenu items. Filter counter Filter counter...........Show the total accumulated time of the filter use timer setting. Timer To set a timer, when the projector reaches the time, the Filter warning icon (Fig.1) appears on the screen and the total accumulated time turns red, indicating that the filter replacement is necessary. Filter counter reset... After replacing the filters, be sure to reset the timer. The Filter warning icon will not turn off until the filter counter is reset. For details about resetting the timer, refer to "Resetting the Filter Counter" on page 61. Fig.1 Filter warning icon Press the SELECT button to select Timer, and then use the Point ▲▼ buttons to set the timer. Select from (Off/1000H/ 2000H/ 3000H/4000H/5000H/6000H) depending on the use environment. Filter warning icon appears on the screen at a set time. (Off/1000H/2000H/3000H/4000H/5000H/6000H). Note: • This icon also appears at turning on. • The Filter warning icon (Fig.1) will not appear when the Display function is set to Off (p.48), during Freeze(p.25), or No show (p.26). 57