Sanyo VCC-HD4000 Instruction Manual, VCC-HD4000P Installation - Page 5

■Rear Face & For connections, see pages 11 and 12. 1 ALARM IN 1 ALARM ALARM OUT IN 2 ABCD E ZOOM COM FOCUS 1Control terminals When connecting the cable, press and hold down the protrusion of the terminal, insert the cable into the terminal, and then release the protrusion. A ZOOM terminal Used to zoom in/out by connecting an external switch. • DC ±(6-12V), +: WIDE, -: TELE B FOCUS terminal Used to perform the focus adjustment remotely by connecting an external switch. • DC ±(6-12V), +: FAR, -: NEAR C COM terminal (Earth terminal) D ALARM OUT terminal Used to connect to an external buzzer or lamp. When an alarm is detected, the device connected to the terminal notifies that an alarm is detected. E ALARM IN 1/2 terminal Used to connect an external alarm switch, infrared sensor, or other device. It can also be used as a switching terminal for color and black/white video modes. 2 ALARM IN 1 ALARM OUT ALARM IN 2 SD OUT POWER ZOOM COM FOCUS GND DC 12V AC24V LAN EX-HDD POWER lamp 3 654 2SD OUT connector (BNC type) Outputs SD (Standard Definition) video. 3AC24V / DC12V terminals Connect this terminal to the power supply. • When the camera is turned on, the POWER lamp lights. 4LAN connector (RJ-45) Used to connect the camera to your network. 5EX-HDD connector Connects this connector to the external hard disk case (VA-HDC4000) dedicated to use with this camera. For details, see the manual for the hard disk case. 6HDMI connector Outputs HD (High Definition) video. Connect this connector to an HD video device. MEMO: Select the SD OUT or HDMI terminal in on the TV OUT SETTING screen via the network. 4