Sanyo WXE45 User Manual - Page 57

Lamp Replacement When the projection lamp of the projector reaches the end of its life, the LAMP REPLACE indicator emits a yellow light. If this indicator lights yellow, replace the lamp with a new one promptly. WARNING: TURN OFF THE UV LAMP BEFORE OPENING THE LAMP COVER Maintenance and Cleaning Top Panel Lamp replacement icon This indicator turns yellow when the projection lamp reaches the end of its life. Note: The Lamp replacement icon will not appear when the Display function is set to "Off" (p.41), during "Freeze" (p.23), or "No show" (p.24). CAUTION Allow the projector to cool for at least 45 minutes before you open the Lamp cover. The inside of the projector can become very hot. CAUTION For continued safety, replace with a lamp of the same type. Do not drop a lamp or touch a glass bulb! The glass can shatter and may cause injury. Follow these steps to replace the lamp. 1 Turn off the projector and unplug the AC power cord. Let the projector cool for at least 45 minutes. 2 Turn the projector over. Remove the screw that secures the lamp cover, and then open the lamp cover. 3 Remove the two screws that secure the lamp. Lift the lamp out of the projector by using the built in handle. 4 Replace the lamp with a new one and secure it with the two screws. Make sure that the lamp is set properly. Put the lamp cover back and secure it with the screw. 5 Connect the AC power cord to the projector and turn on the projector. 6 Reset the lamp replacement counter. See "Lamp Replacement Counter" on the next page. Lamp Cover Screw Lamp Screw Screw Handle ORDER REPLACEMENT LAMP Replacement lamp can be ordered through your dealer. When ordering a projection lamp, give the following information to the dealer. ●Model No. of your projector : PLC-WXE45 ●Replacement Lamp Type No. : P��O�A�-�L�M�P��1�0�6� (Service Parts No. 610 332 3855) 57