Schwinn 101 Upright Bike Assembly Manual - Page 12
Attach, Handlebar, Assembly, Computer/Handlebar
View all Schwinn 101 Upright Bike manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 12 highlights
Assembly Stage #5 Attach Handlebar Assembly to Computer/Handlebar Mast 7 2 8 6 9 10 ll 2 Assembly Hardware Required: (1) Allen Bolt M7 x P1.0 x 30mm(item #6) (1) T-knob Bushing (item #8) (2) Spring Washer (item #10) (2) Washer (item #11) L Place HANDLEBAR ASSEMBLY (#2) in the groov COMPUTER/HANDLEBAR MAST (#5 anc pace HANDLEBAR CLAMP (#12) over the top of the middle of the HANDLEBAR (#2). Then place „HANDLEBAR CLAMP COVER (#9 over the CLAMP and HAND). FBARS. Fasten with the HANDLEBAR BOLT ), SPRING WASHER,(#10), and . WARIER (#11), • 2. Further tighten the handle bar and clamp system by inserting the T-KNOB (#7) and T-KNOB BUSHING (#8) through the HANDLEBAR. CLAMP COVER and placing the SPRING WASHER (#10) and WASHER (#11) between the COVER and the CLAMP. Before fully tightening the T-knob, adjust the handlebars to desired position and then fully tighten T-knob, 3. ,Attach HR CABLE extending from the Handlebar to the HR cable extending from the computer/handlebar mast. 11