Schwinn A20 Recumbent Bike 2013 Model Assembly and Owner's Manual - Page 11
Install Console Mast to Main Assembly, Attach Media Tray to Console and Install the Console to
View all Schwinn A20 Recumbent Bike 2013 Model manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 11 highlights
7. Install Console Mast to Main Assembly Note: You can attach a wire (or string) to the Console Cable and HR Cable to help pull the cables through the Console Mast. NOTICE: D o not crimp cables. 9 X3 D B 6mm 8. Attach Media Tray to Console and Install the Console to the Console Mast Note: Before you attach the Media Tray, remove the protective plastic film from the front of the console. Be sure the tabs on the Media Tray snap into the Console. Remove the pre-installed screws from the back of the Console before you connect the cables. NOTICE: Do not crimp cables. Make sure that the switch (10a) on the back of the Console is set to B (bike). 10 10a 14 10 #2 11
11
7. Install Console Mast to Main Assembly
Note:
You can attach a wire (or string) to the Console Cable and HR Cable to help pull the cables through the
Console Mast.
NOTICE:
Do not crimp cables.
X3
B
D
6mm
9
10a
#2
10
8. Attach Media Tray to Console and Install the Console to the Console Mast
Note:
Before you attach the Media Tray, remove the protective plastic film from the front of the console. Be sure the
tabs on the Media Tray snap into the Console.
Remove the pre-installed screws from the back of the Console before you connect the cables.
NOTICE:
Do not crimp cables. Make sure that the switch (10a) on the back of the Console is
set to
B
(bike).
10
14