Schwinn A20 Recumbent Bike 2013 Model Assembly and Owner's Manual - Page 26

Console shuts off (enters sleep mode) while in use Unit rocks/does not sit level Pedals loose/unit difficult to pedal Clicking sound when pedaling Seat post movement Check data cable integrity All wires in the cable should be intact. If any are cut or crimped, replace cable. Check data cable connections/orientation Be sure cable is connected securely and oriented properly. Small latch on connector should line up and snap into place. Reset machine Unplug unit from electrical outlet for 3 minutes. Reconnect to outlet. If bike has batteries, check If the battery level shows low or no power, replace the Battery Level icon on console batteries. or check batteries. Check magnet position (re- Magnet should be in place on pulley. quires shroud removal) Check RPM Sensor (requires shroud removal) RPM sensor should be aligned with magnet and connected to data cable. Realign sensor if necessary. Replace if there is any damage to the sensor or the connecting wire. Check leveler adjustment Leveling feet may be turned in or out to level bike. Check surface under unit Check pedal to crank connection Check pedal to crank connection Check locking pin Check adjustment knob Adjustment may not be able to compensate for extremely uneven surfaces. Move bike to level area. Pedal should be tightened securely to crank. Be sure connection is not cross-threaded. Remove pedals and reattach fully. Be sure adjustment pin is locked into one of the seat post adjustment holes. Be sure knob is securely tightened. 26