Seagate ST300MM0026 Savvio 10K.1 SAS Product Manual - Page 57

9.3.1 Inquiry data Table 18 lists the Inquiry command data that the drive should return to the initiator per the format given in the SAS Interface Manual. Table 18: Savvio inquiry data Bytes Data (hex) 0-15 16-31 00 00 03** 12 8B 00 PP 0A 53 45 41 47 41 54 45 20 Vendor ID [53 54 39 37 33 34 30 31 53 53 20]1 20 20 20 20 20 Product ID 32-47 R# R# R# R# S# S# S# S# S# S# S# S# 00 00 00 00 48-63 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 64-79 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 80-95 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 96-111 00 43 6F 70 79 72 69 67 68 74 20 28 63 29 20 32* *Copyright 112-127 30* 30* 35* 20 53 65 61 67 61 74 65 20 41 6C 6C 20 notice 128-143 72 69 67 68 74 73 20 72 65 73 65 72 76 65 64 20 * Copyright year (changes with actual year). ** 02 = SCSI-2 implemented with some SCSI-3 features (default). 03 = SCSI-3 implemented. PP 10 = Inquiry data for an Inquiry command received on Port A. 30 = Inquiry data for an Inquiry command received on Port B. R# Four ASCII digits representing the last four digits of the product firmware release number. S# Eight ASCII digits representing the eight digits of the product serial number. [ ] Bytes 18 through 26 reflect model of drive. The table above shows the hex values for Model ST973401SS. Refer to the values below for the values of bytes 18 through 26 of you particular model: ST973401SS 53 54 39 37 33 37 30 31 53 53 ST936701SS 53 54 39 33 36 37 30 31 53 53 9.3.2 Mode Sense data The Mode Sense command provides a way for the drive to report its operating parameters to the initiator. The drive maintains four sets of mode parameters: 1. Default values Default values are hard-coded in the drive firmware stored in flash E-PROM (nonvolatile memory) on the drive's PCB. These default values can be changed only by downloading a complete set of new firmware into the flash E-PROM. An initiator can request and receive from the drive a list of default values and use those in a Mode Select command to set up new current and saved values, where the values are changeable. 2. Saved values Saved values are stored on the drive's media using a Mode Select command. Only parameter values that are allowed to be changed can be changed by this method. Parameters in the saved values list that are not changeable by the Mode Select command get their values from default values storage. When power is applied to the drive, it takes saved values from the media and stores them as current values in volatile memory. It is not possible to change the current values (or the saved values) with a Mode Savvio SAS Product Manual, Rev. D 51