Seagate ST9250412AS Momentus 7200 FDE.1 SATA Product Manual - Page 29

Drive mounting

Page 29 highlights

3.4 Drive mounting You can mount the drive using four screws in the side-mounting holes or four screws in the bottom-mounting holes. See Figure 4 for drive mounting dimensions. Follow these important mounting precautions when mounting the drive: • Allow a minimum clearance of 0.030 inches (0.76 mm) around the entire perimeter of the drive for cooling. • Use only M3 UNC mounting screws. • Do not overtighten the mounting screws. Maximum torque: 4.0 inch-lb (0.4519 N-m). • Four (4) threads (0.080 inches, 2.032 mm) minimum screw engagement recommended. • Avoid excessive drive distortion when mounting. Measurements shown in Figure 4 are in inches. 3.95 +/- .010 Breather Hole Do not cover or seal. + Recommended case temperature measurement location Figure 4. Mounting dimensions Momentus 7200 FDE.1 SATA Product Manual, Rev. B 23

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62
  • 63
  • 64

Momentus 7200 FDE.1 SATA Product Manual, Rev. B
23
3.4
Drive mounting
You can mount the drive using four screws in the side-mounting holes or four screws in the bottom-mounting
holes. See Figure 4 for drive mounting dimensions. Follow these important mounting precautions when mount-
ing the drive:
Allow a minimum clearance of 0.030 inches (0.76 mm) around the entire perimeter of the drive for cooling.
Use only M3 UNC mounting screws.
Do not overtighten the mounting screws. Maximum torque: 4.0 inch-lb (0.4519 N-m).
Four (4) threads (0.080 inches, 2.032 mm) minimum screw engagement recommended.
Avoid excessive drive distortion when mounting.
Measurements shown in Figure 4 are in inches.
Figure 4. Mounting dimensions
+
Recommended
case temperature
measurement
location
Breather Hole
Do not cover
or seal.
3.95 +/- .010