Seagate STD224000N Installation Manual - Page 11
Location of jumper blocks on 3.5-Inch internal, drives
UPC - 662676603727
View all Seagate STD224000N manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 11 highlights
Seagate DAT Drive Installation Manual 7 Power-on self-test enable/disable (switch S8) The S8 switch enables or disables execution of power-on self-test diagnostics when the drive is powered on. If S8 is ON, the drive responds to SCSI commands only after successful completion of the self-test (about 5 seconds). Switches 9 and 10 These switches are only present on DDS-3 drives. They are reserved and should not be used. Jumper settings The configuration jumpers are used to control SCSI bus termination and terminator power. The jumpers can also be used for remote SCSI address selection. Figures 4 and 5 show the locations of the jumper blocks for the 3.5-inch and 5.25-inch internal DAT drives, respectively. Figure 4 Location of jumper blocks on 3.5-Inch internal drives Jumper Block Pin 1 SCSI Connector Power Connector