Seagate STM303004N1AAAS-RK DiamondMax 21 SATA Product Manual - Page 35
Configuring and mounting the drive
![]() |
UPC - 751921029914
View all Seagate STM303004N1AAAS-RK manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 35 highlights
3.0 Configuring and mounting the drive This section contains the specifications and instructions for configuring and mounting the drive. 3.1 Handling and static-discharge precautions After unpacking, and before installation, the drive may be exposed to potential handling and electrostatic discharge (ESD) hazards. Observe the following standard handling and static-discharge precautions: Caution: • Before handling the drive, put on a grounded wrist strap, or ground yourself frequently by touching the metal chassis of a computer that is plugged into a grounded outlet. Wear a grounded wrist strap throughout the entire installation procedure. • Handle the drive by its edges or frame only. • The drive is extremely fragile-handle it with care. Do not press down on the drive top cover. • Always rest the drive on a padded, antistatic surface until you mount it in the computer. • Do not touch the connector pins or the printed circuit board. • Do not remove the factory-installed labels from the drive or cover them with additional labels. Removal voids the warranty. Some factory-installed labels contain information needed to service the drive. Other labels are used to seal out dirt and contamination. DiamondMax 21 Serial ATA Product Manual, Rev. C 29
![](/manual_guide/products/seagate-stm3320820as-diamondmax-21-sata-product-manual-2216d69/35.png)