Sharp 25NS100 25NS100|25NS180|27NS100|27NS180 Operation Manual - Page 33

Using the Video and Audio Input Jacks (Continued) L To watch video material playback. • Press the Remote's INPUT to select VIDEO INPUT mode to which the video equipment you want to playback is connected. • The external VIDEO INPUT mode will change as follows each time the INPUT is pressed. • INPUT mode can be selected by pressing either the CH UP (8) on the TV remote control when the TV is set to the highest channel stored in memory, or by pressing the CH DOWN (9) when it is set to the lowest channel. NOTE: • When connecting video or audio equipment to the television, be sure that the power is turned off in order to prevent damage to either the television or the equipment being connected. • The S-VIDEO terminal has priority over a VIDEO terminal (IN-1). When you want to watch pictures from video equipment connected to a VIDEO terminal, unplug equipment connected to the corresponding S-VIDEO terminal. • It is the intent of SHARP that this product be used in full compliance with the copyright law and that prior permission be obtained from copyright owners whenever necessary. • For detailed information on the connection and use of auxiliary equipment, refer to the instruction manuals of the equipment being used. • The connection cords can be obtained from your local video store. Using the Audio Output Jacks (25N-S180 and 27N-S180 only) L These jacks are used for connecting a standard stereo amplifier. Control of STEREO/MONO/ SAP, VOLUME and MUTE are retained at the TV. These jacks relay the audio signal of all programs being displayed on the TV screen. (1) Before connecting the (AUDIO OUTPUT JACKS are located on the rear of the cabinet.) cord, turn on the TV and adjust the VOLUME CONNECTIONS control on the TV for a moderate listening level. (2) Turn off the TV and (Rear connection terminals of TV) connect the audio cord to the AUDIO LINE OUTPUT JACKS on the TV. (3) Turn the TV set and stereo amplifier on. (4) If you desire, you can turn off the sound to the TV's internal speakers by SPEAKER mode. See page 13 - 14. (5) Adjust the VOLUME control on the stereo amplifier for a moderate listening level. (6) Control of the audio can be done using the audio controls (STEREO/MONO/SAP, VOLUME, and MUTE), from either the remote control, or directly from the TV set. NOTE: • For detailed information on the connection and use of auxiliary equipment, refer to the operation manuals of the equipment being used. • When connecting monaural equipment to the AUDIO INPUT or OUTPUT of this set, use an audio connection cord and plug adapter as shown below. • For optimal sound quality, it is recommended to keep the TV's audio output level high. To the TV Pin plug x 2 Plug adapter Pin plug Pin jack/Mini plug To the equipment being connected 33 32-40 25&27NS100/180 1.4 33 6/1/00, 2:12 PM