Sharp 8M-B70AU Quick Start Setup Guide 8M-B70AU - Page 22

Names of Monitor Parts and Remote Control Buttons Parts of the Monitor  Rear  Front Brightness sensor/remote control receiver => Page EN 1 • Point the remote control unit toward this part. POWER lamp • Green light ON: In operation • Red light ON: In standby • OFF: Power off  Main body controls Power button MENU button Input 7 A~D (HDMI) • 8K signal terminal INPUT button • On the Setup menu => "Enter" button  forward/ backward buttons • On the Setup menu => "Upward/Downward cursor" button • "" button functions as "Upward cursor", and "" button functions as "Downward cursor". Volume (+/-) buttons • On the Setup menu => "Right/Left cursor" button • "+" button functions as "Right cursor", and "-" button functions as "Left cursor". If a message "The operation with remote control is prohibited" appears on the screen Release the lock using the operation buttons on the main body. 1) Press the home button on the main body. 2) Select Setup using the volume buttons on the main body and then press the INPUT button. 3) Select Ecology > "Operation Lock" using the volume buttons and selection buttons, and then press the INPUT button. 4) Select Off and press the INPUT button. Input 6 Digital audio output terminal (optical) Input 4 (HDMI) LAN terminal (10BASE-T/100BASE-TX) • Use this terminal for IP control, etc. EN 7 Headphone jack (3.5 stereo mini jack) • Audio can be output from the speakers even when headphones are connected. (Refer to "Menu Operation" in the built-in Operation Manual.) USB1 terminal • Use this terminal to view photos, music, and video stored in USB memory. USB2 terminal Input 1 to 3 (HDMI) Input 5 Audio input: Input 1/Input 6/Input 7 Analog audio output terminal (3.5 stereo mini jack)