Sharp AF-S60EX AFS50EX|AFS60EX Operation Manual - Page 13

HOW TO OPERATE ENERGY SAVER OPERATION During normal operation, the thermostat automatically controls cooling and the fan runs continuously. When the ENERGY SAVER OPERATION is selected, the thermostat automatically controls cooling and the fan automatically stops when the compressor is not operating. (Fan will stop 30 seconds after the compressor stops. After the fan stops, the fan is programmed to rotate for approx. 2 minutes to detect room temperature. This will occur within a 20 min time span.) ENERGY SAVER indicator F POWER hr ON/OFF During cooling operation 1 Touch ENERGY SAVER pad. • ENERGY SAVER indicator will light. SLEEP COOL TEMP SELECTOR TIMER ON/OFF ENERGY SAVER ENERGY SAVER pad 2 To cancel, touch ENERGY SAVER pad again. • ENERGY SAVER indicator will go off. NOTE: ENERGY SAVER OPERATION cannot be set during fan only operation. SLEEP OPERATION When SLEEP OPERATION is set, the temperature setting is automatically adjusted to prevent the room from becoming too cold while you sleep. One hour after the SLEEP OPERATION is started, the temperature setting rises 2°F higher than the original temperature setting. The temperature will return to its original setting after 8 hours. SLEEP indicator F hr POWER ON/OFF During cooling operation 1 Press the SLEEP button on the remote control. SLEEP SLEEP COOL TEMP SELECTOR TIMER ON/OFF ENERGY SAVER • SLEEP indicator will light. 2 To cancel, press the SLEEP button again. • SLEEP indicator will go off. NOTE: • SLEEP OPERATION cannot be set during fan only operation. • SLEEP OPERATION will be cancelled in 5 seconds, when cooling operation is changed to fan only operation while SLEEP OPERATION is set. 13